A blog about electronics and programming

Home › Forums › Mastering STM32 book support forum › What to read before studying your book


Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 4, 2022 at 8:54 pm #74068
    tomy
    Participant

    Hi Carmine,

    Thank you for your book. I was reading it with high enthusiasm until I reached the section where you have written that the book might not be for those who haven’t any experience with embedded programming!

    I’m an experienced C++ programmer but very new to embedded programming and have bought an STM32F411RE Nucleo-64 board just for the purpose of embedded programming.
    Please help and suggest me some book or tutorial to read and then to be able to read your book and understand it well.

    Thanks so much for your help.

    February 6, 2022 at 4:43 pm #74072
    tomy
    Participant

    Isn’t there any answer to my question, please?

    February 10, 2022 at 7:23 am #74078
    Carmine Noviello
    Keymaster

    Hi,
    Sorry for the late reply but email notifications are totally broken and I have to fix them.

    Well, your question is not trivial to answer. The learning curve of a complex STM32F4 MCU may be too steep if you are new to electronics and embedded programming. It depends a lot on the time you want to dedicate to the learning process. Sometimes you spent a lot of time just understanding the concepts before going into technicalities. I do all my best to keep things simple, but I assume you have a little of experience with embedded programming. You could start by learning simpler architectures (like Arduino) so that you can acquire the very basic concepts. Don’t give up, it’s just a matter of time.

    February 10, 2022 at 11:28 pm #74082
    tomy
    Participant

    Thank you for your reply. Still have a couple of questions!
    1) Do I need to search for a book/tutorial or series about the Arduino itself or embedded programming on Arduino? About the time, I can manage my schedule to dedicate enough time to that.

    2) Now I only have a blue pill, some cables and USB connectors plus a STM32F411 Nucelo-64 board. Do I need more stuff to buy to get started and program a few embedded examples?

    Thank you for your time and help.

    February 11, 2022 at 4:42 pm #74085
    Carmine Noviello
    Keymaster

    The hardware in your hands is sufficient for almost all book examples. So I think it’s ok to start with it.
    So, forget the Arduino and go ahead with the book. If you give you time you should be able to start working with STM32 without problems.

  • Author
    Posts

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.